Hi Ravi,
The voltage of VPROPI is just the Iout/2000*R_VPROPI. If you have 3K resister, when Iout = 2A, the voltage seen should be 3V. Must be < (VCC-1V)
But to get the wanted output voltage, you need to use the proper decay ways. Follow 7.3.3 of the datasheet.
Becuse the Iout/2000 to the pin is only based on the high side FETs.
Best regards,
The voltage of VPROPI is just the Iout/2000*R_VPROPI. If you have 3K resister, when Iout = 2A, the voltage seen should be 3V. Must be < (VCC-1V)
But to get the wanted output voltage, you need to use the proper decay ways. Follow 7.3.3 of the datasheet.
Becuse the Iout/2000 to the pin is only based on the high side FETs.
Best regards,
