Kwan,
The resistors only need to change if your max current will exceed the allowed value. You can use the same value for any current below the max current. If you would like finer resolution then you can change this resistor lower.
For more info on the voltage filter pole, please see section 5.2.3 and 5.2.4 of the Instaspin Guide: www.ti.com/.../spruhj1g.pdf
Regards,
-Adam
The resistors only need to change if your max current will exceed the allowed value. You can use the same value for any current below the max current. If you would like finer resolution then you can change this resistor lower.
For more info on the voltage filter pole, please see section 5.2.3 and 5.2.4 of the Instaspin Guide: www.ti.com/.../spruhj1g.pdf
Regards,
-Adam