Hi Rick,
Thanks again for your answer and working on a Saturday! If I could, I'd send a beer.
I have the MSP-EXP430G2 so maybe I can do this today.
From that are the following true:
1) I need to rotate the 2 far left (RXD/TXD) jumpers 90degrees as they are in the picture in your document (highlighted in green below)
2) The pins connect straight across if both J4 jumpers are in parallel (highlighted in yellow below).I tried to determine from both schematics which pin connects where but couldn't quite figure this out so I have assumed that the example in your document (J4-J2) is the same for the J4-J4 on the DRV8313EVM.
Thanks again,
Adam
