Hi David,
I am assuming you are concerned about the CC3200 Pad state after power up but prior to reset. Is that correct?
I suggest you confirm the worst case pullup current with the CC3200 forum. This will allow you to properly size external pulldown resistor. You may find a 33k external pulldown will work.
If it does, this will save a few mA when the device is active.
I am assuming you are concerned about the CC3200 Pad state after power up but prior to reset. Is that correct?
I suggest you confirm the worst case pullup current with the CC3200 forum. This will allow you to properly size external pulldown resistor. You may find a 33k external pulldown will work.
If it does, this will save a few mA when the device is active.