Hi Asif,
Yes, you can pull the WAKE input pin high using a resistor. Doing so disables sleep mode increases the current used by the DRV8305 from <100uA typ to 4mA typ. If you are trying to reduce current when idle, it is recommended to control the WAKE pin.
PWRGD is an open drain output, which is why there is a pullup attached.
Yes, you can pull the WAKE input pin high using a resistor. Doing so disables sleep mode increases the current used by the DRV8305 from <100uA typ to 4mA typ. If you are trying to reduce current when idle, it is recommended to control the WAKE pin.
PWRGD is an open drain output, which is why there is a pullup attached.