Part Number: CSD88537ND
Dear Community,
I understand the working of Mosfets in general but I have this doubt, Assume I have CSD88537ND
And now I make the following connection
1. connect the pin 8 ( D1) to +24v
2. connect the pin 2 (G1 ) to an MCU which can give 5v and 20mA for logic high
3. connect the pin 1 (S1 ) to a floating wire of a Car
Here is what I want to achieve
1. Pull the floating wire of car to +24v if i give logic high of 5v and 30mA from MCU pin
2. Pull the floating wire of car to GND if i give logic low from MCU pin - ( In This case D1 is connected to GND )
Will the above work ? Is my understanding of this mosfet working correct ?
If not can you suggest me a different mosfet ? All I want to do is pull a floating wire of a car to VCC or GND from MCU via MOSFET !!
My mosfet should be able to able to handle pulsed current of 100A and continuous of around 20A, ( + or - is fine )
Regards
Shashank