Hello Luis-san,
Thank you for your reply.
The customer's setting as follows,
VM=24V
full scale current = 390mA
non-circular 1/2 stepping operation
The motor current is under control at CW direction.
The customer stop the motor with nSLEEP assert.
Next, the customer drive the motor with CCW direction,
the motor current flow as over 1A. It is not under control.
Best Regards,
Naoki Aoyama
Thank you for your reply.
The customer's setting as follows,
VM=24V
full scale current = 390mA
non-circular 1/2 stepping operation
The motor current is under control at CW direction.
The customer stop the motor with nSLEEP assert.
Next, the customer drive the motor with CCW direction,
the motor current flow as over 1A. It is not under control.
Best Regards,
Naoki Aoyama