Hi Rick,
nSleep is logic high yes, I put the correct cap values and the motor turns now in one direction only. If I swap the input pins to VCC/GND nothing happens. I haven't found the reason for this yet. Also I didn't see any mention in datasheet that nFault needs to have an external pullup other than maybe in Figure 10. Thanks for the help!
Kenny
nSleep is logic high yes, I put the correct cap values and the motor turns now in one direction only. If I swap the input pins to VCC/GND nothing happens. I haven't found the reason for this yet. Also I didn't see any mention in datasheet that nFault needs to have an external pullup other than maybe in Figure 10. Thanks for the help!
Kenny