Hi Jesal,
Is your problem with the DRV8301 or the LaunchXL28069? If SPI_CLK is not showing up, this appears to be a problem with the LaunchXL28069.
The procedure is listed in the datasheet starting at section 7.5.1
I suggest you focus on reading register 0x2, which should reply with 0x200
Also please note section 7.4.1: SPI communication is supported when EN_GATE is low.
Is your problem with the DRV8301 or the LaunchXL28069? If SPI_CLK is not showing up, this appears to be a problem with the LaunchXL28069.
The procedure is listed in the datasheet starting at section 7.5.1
I suggest you focus on reading register 0x2, which should reply with 0x200
Also please note section 7.4.1: SPI communication is supported when EN_GATE is low.