RE: DRV10983: Overcurrent

Hi Bradey,


What happens when you switch to close loop ? You can disable fault 0 lock detection on Advanced setting page by unchecking 'Current limit' lock. Lock 0 is getting triggered because the motor current is higher and it closer to limit of 3A. So disabling acceleration current limit wont help. Can you try to tune 'T control Advance time' on basic setting page.

Can you share phase current waveforms ?

Can you check box for double the output PWM frequency on Advanced setting page, since you are trying to operate at high speed higher PWM switching frequency should help.

Regards,
Krushal