Hi Nakai-san,
Q1. On pin function table in the device datasheet(SLVSDA4), 0.47uF ceramic capacitor should be placed between DVDD and GND, AVDD and GND. What is allowance of this capacitor? Can 1uF be used?
We will investigate and reply in a few days.
Q2. Can M0,M1,TRQ pin be often changed during powered on? Is there any timing which those pins levei must not be changed?
M0 and M1 changes are accepted when the STEP signal rises. TRQ can be changed at any time.
Q3. In their evaluation. the squeal of motor is large. So they will try to use slow decay mode. When slow decay mode is used, is there any point to make note for slow decay using?
Slow decay may not work at slow speeds. Be sure to monitor the current waveforms at all speeds.
Q1. On pin function table in the device datasheet(SLVSDA4), 0.47uF ceramic capacitor should be placed between DVDD and GND, AVDD and GND. What is allowance of this capacitor? Can 1uF be used?
We will investigate and reply in a few days.
Q2. Can M0,M1,TRQ pin be often changed during powered on? Is there any timing which those pins levei must not be changed?
M0 and M1 changes are accepted when the STEP signal rises. TRQ can be changed at any time.
Q3. In their evaluation. the squeal of motor is large. So they will try to use slow decay mode. When slow decay mode is used, is there any point to make note for slow decay using?
Slow decay may not work at slow speeds. Be sure to monitor the current waveforms at all speeds.