Jumper settings are exactly the same as default settings. (Hall sensor is again single-ended and no EEPROM).
Also, this is the real motor datasheet. (Just connections are different from the previous one). I have connected these wires:
PIN1. U --> P2.U
PIN2. V --> P2.V
PIN3. W --> P2.W
PIN4. GND --> P3.HGND
PIN5. Hall2 --> P3.HV+
PIN6. Hall1 --> P3.HU+
PIN7.Hall3 --> P3.HW+
PIN8.VHall 5VDC --> P3.HPWR
As I said before this was my default wirings which was changed to get the system to work. I exchanged V+ and W+ wires and the rotation in just one direction with HALLPOL=1 became smooth.