Part Number: drv8320
Hi
I'm evaluating DRV8320H using BOOSTXLDRV8320H EVM.
The requirement is sensored application, so I followed the user guide, the sensored project was built and loaded to device.
I believe there is no problem up to this point.
However, I could not start motor in BOOSTXL-DRV832x GUI.
I got the following status.
Regarding to status of LED1 and LED2 on MSP430F5529LP board, LED1 is "toggle", LED1 is "on".
The other configuration is below.
Before this evaluation, I populated R35, R36 and R38 with 0ohm for PWM inputs.
And I set 1x PWM Mode in the GUI, and start motor driving.
The tool version is below.
GUI : v1.0.0 (3fb7e5)
CCS : version 7.4.0
Motor: TelcoMotion DT4260-24-055-04H-TI
As a side note, a sensorless software worked properly with same motor.
Can you see the reason why my sensored software is not worked?
BestRegards