Hi,
The hall sensor pins should be connected based on the motor datasheet.
Are you able to see the three H+ pins toggling between different states if VREG is up and you manually spin the motor? Do this without supplying a PWM signal to the driver.
Is your power supply current limiting during motor startup with your board and not during the EVM?
The hall sensor pins should be connected based on the motor datasheet.
Are you able to see the three H+ pins toggling between different states if VREG is up and you manually spin the motor? Do this without supplying a PWM signal to the driver.
Is your power supply current limiting during motor startup with your board and not during the EVM?