ok I understand now, I was confused on the terminology between integrated and pre-driver. Some of the integrated drivers have the controllers (ie: DRV10x) versus some that don't but have FETs.
Also, on some of the datasheets (ie: DRV8305) that says it has 1.25V and 1A peak gate drive currents. How exactly would the gates of the FETs experience that amount of peak current, especially if you limit it with a series resistor? If you don't have the series resistor, then I am assuming the peak current is probably some kind of transient effect when driving PWM signal?
Thanks
-David
Also, on some of the datasheets (ie: DRV8305) that says it has 1.25V and 1A peak gate drive currents. How exactly would the gates of the FETs experience that amount of peak current, especially if you limit it with a series resistor? If you don't have the series resistor, then I am assuming the peak current is probably some kind of transient effect when driving PWM signal?
Thanks
-David