Hi Phil,
I tried the above method but still, the motor does not stop in the given angle, it just slides down the circle. Any other method suggest.
What I did.
Method 1 what we tried
1) Enabled all the three phase high (100%) duty Cycle.
2) Disabled all the low side of the Half bridge.
when the motor is stopped.
Method 2 What we tried:
1) All high side of the half bridge with 0% Duty Cycle.
2) Only Two phase of the low half bridge was energized.
When the motor is stopped.
But none of the both methods worked for us..
Regards
Mahesh Prasath
I tried the above method but still, the motor does not stop in the given angle, it just slides down the circle. Any other method suggest.
What I did.
Method 1 what we tried
1) Enabled all the three phase high (100%) duty Cycle.
2) Disabled all the low side of the Half bridge.
when the motor is stopped.
Method 2 What we tried:
1) All high side of the half bridge with 0% Duty Cycle.
2) Only Two phase of the low half bridge was energized.
When the motor is stopped.
But none of the both methods worked for us..
Regards
Mahesh Prasath