Hi Robert,
I'm glad you were able to remove the fault.
For the new issue of not being able to toggle the GHC, a have a couple questions:
1.) Does replacing R1008 solve this issue? Are you sure the input voltage is making it to the device input pin (INHC)?
2.) Does replacing R1013 with a 0 Ohm resistor solve this problem?
I'm glad you were able to remove the fault.
For the new issue of not being able to toggle the GHC, a have a couple questions:
1.) Does replacing R1008 solve this issue? Are you sure the input voltage is making it to the device input pin (INHC)?
2.) Does replacing R1013 with a 0 Ohm resistor solve this problem?