Hi
I installed DRV8880EVM and tested all by changing parameters.
As I understand, this DRV8880EVM application uses "DRV8880EVM_v1p1.out" in target directory to upload FW to F2617 target device on uploding every power up.
Is it right?
How to modify the GUI application for PC side? Should I use GUI composer?
I tried but it says
"Problem accessing /gc/webapp1/DRV8880EVM/app.html. Reason: Not Found "
I think this GUI application is not compatible to GUI composer tool..
Is there any way to modify the GUI code?
Is there any way to upload FW to target after compile the FW source?
Regards
DC Kim