Hy, i have a big problem with a Motors (is a Motorgear) control that use DRV8842 (attach the drawing) pilot normally 24 VDC Motor:
24 VDC Motor 4 Ampere Coil 3,2mH at 1Khz 5,8 Ohm Motors DC resistance, the VM Supply is about 36 Volt.
It seems to be all right everything. But somewtimes after start Motor little seconds (0,4 / 0,5 sec ....) the Driver STOP motor with nFAULT protections active.
I think is for the OCP protection! overcurrent. Because i must active nRESET OFF/ON for restart the Motor.
I have 2.200 uF capacitor in the VM Power Supply, and 2,2 uF plus 220nF near the 8842 IC.
I don't think to have exessive peak motor current, and with Vref setting at 3,3 A max is possible to reach the protection?
Pwm setting in 5Khz, Slow or Fast Decay seems indifferent ??, How can i do for not have the STOP Motor ??
Thank you